You should bury SWA, as if you accidentally cut through it could be fatal. This gives you good metal-to-metal contact - which will effectively earth the armouring. How to Install Sod 15 Steps. If a light does not come on, check that your waterproof connector has been fully clamped down. All rights reserved. Strip 6cm of outer sleeve from the cable attached to your light.
Test each channel to make sure all your lights are working.
How Our Plug & Play Lighting Works
Or switch off the breaker and lock it if you can. Strip the ends of the low-voltage power cable, and connect them to the terminals on the transformer. Tape a loop in the cable around 20cm long where each light is required. Sign Up for More No Thanks. Your light will now be connected to your supply cable. How to run a spur from a power circuit If you decide to run an outside wall light off a main power circuit which you'll need to do if you plan to fit a high-wattage floodlightfirst identify a suitable socket from which to run a spur.